DIRECT STEAM INJECTION UHT/HTST

DIRECT STEAM INJECTION UHT/HTST

MANUFACTURER: POWERPOINT INTERNATIONAL (P2K) – JAPAN

ORIGIN: JAPAN

Advantages Direct Steam Injection UHT/HTST: 

UHT-HTST from POWERPOINT INTERNATIONAL (P2K) is designed to be portable, can move from one position to another very easily and can be placed in a wet or dry area.

Features  Direct Steam Injection UHT/HTST: 

Direct Steam Injection UHT/HTST

• The machine can be supplied with tubes, plates or both. Processing using either direct heating or
  indirect heating at temperatures to 152 deg C and flow rates from 10 to 40 Ltr per hour.
  Easy changeover from direct heating or indirect heating by the touch of a button. Just select which
  system is to be used from the touch panel menu and the machine is ready to use.
  Individual tubes are utilized to give a wide variety of heating and cooling duties. The tubes are
  manufactured to our own specification and are profiled to give turbulence at the low flow rates to
  enable scale up to production.

• No bond Gasketed plate heat exchangers to give a wide variety of heating and cooling duties. The
  plates are manufactured to our own specification and can be supplied as 1 complete plate pack or
  individual units for easy maintenance.
• Minimum sample required.
• Flow rates from 10 to 40 Ltr per hour (Higher available by request).
• Highly accurate electromagnetic flowmeter as option.
• Product system pressures to 10 bar.

• Heating to 152 deg C at the flow rates stated.

• Cooling to below 5 deg C at the flow rates stated.
• Holding tubes of any time available and can be placed wherever needed.
• Built in refrigerator or your chilled water supply.
• Built in true CIP (Clean In Place), flow for CIP more than 500 Ltr per hour.
• Each heating section is individually controlled to enable a wide setting of product temperatures.
• 2 Electrically heated hot water recirculators.
• Touch panel control fascia with flow path of system.
• Vacuum pump to 400 mbar.
• PID controlled steam valve.
• SIP (Sterilise In Place) an option for Aseptic sampling.
• Aseptic sampling when used with the optional Clean Bench.
• In line homogeniser can be added either upstream or downstream.

• Level sensor in hopper for easy wash out after product and CIP.

• Computer interface with real time temperature

Control Direct Steam Injection UHT/HTST: 

            Control

• Each section is individually controlled and the flow path of the system is shown on the touch panel.
  The product is heated by pressurised hot water recirculators, or steam for the 2nd stage when
  using the direct heating, which are PID controlled for greater stability and accuracy.
• The cooling is in 1 or 2 stages dependant on the final cooling temperature required.

Basic technical parameter:

• Steam, mains water and a suitable drain required.
• Compressed air at 6 bar for the divert valves.
• Voltages available
  200, 220 or 240 volt single phase, 50 or 60 Hz.
  200 volt 3 phase, 50 or 60 Hz.
  380 volt 3 phase, 50 or 60 Hz.
  415 volt 3 phase, 50 or 60 Hz
• Amps: Depending on voltage, minimum 20 amps, maximum 45 amps

For more information about products, please contact to Exclusive Representative in Vietnam: Rong Tien Co., Ltd.